SR SMITH 6" VINYL LINER POOL ANCHOR

Write a Review

SR SMITH 6" VINYL LINER POOL ANCHOR

Rating Required

Name

Email Required

Review Subject Required

Comments Required

$80.01

SKU:: VL-ANCHOR-1.90
Weight:: 3.00 LBS
Shipping:: Calculated at Checkout

Description
Show Reviews

SRS 6" Vinyl Liner Pool Anchor With Cap, For 1.90" OD Tubing

To avoid entrapment Do Not Install near walls or other objects where there will not be sufficient clearance when used with a 16" or 30" diameter table or seat.

Instructions:

Check your local electrical code for bonding requirements
Locate suitable location for anchor installation
Allow sufficient clearance for use of either the 16" or 30" diameter tables and seats
Anchor must be set in concrete in a minimum size pour of 24" L x 24" W x 12" D, allowing a minimum thickness below anchor of 4"
Make sure the anchor is level and the top of the body is flush with the top of the concrete (insure no concrete gets into the body during pour)
When concrete is cured, install gasket, liner and faceplate per manufacturer's specifications
Use included cap when anchor is not being used

Important Notice: Install black plastic cap on anchor end of support pole to prevent damage to pool vinyl liner.

Warning: Important Installation Information

The Installation of this product should be done only by a licensed and professional installer. Installation should be done strictly in conformance with all local building codes, electrical codes and other building and safety laws and regulations. Among other things, that your installer should carefully analyze the need to bond the product to prevent an electrical hazard. Failure to properly install this product could result in a dangerous condition, including but no limited to electrical or structural hazards. Inter-Fab disclaims all liability arising from the installation and the user assumes all risk associated with the installation.